C10 Communications Pty Ltd C10100E Central ADSL Filter/Splitter for centrally separating the ADSL signal and voice frequency signal. No distributed (inline) filters are required in this installation. It can be mounted on an external / outdoor wall as if mounted vertically, it has a rubber grommet to seal the base of the unit where the cable enters.
Also available under the brand names of "Jackson" & "Data Bitz".
If you suffer ADSL2/2+ dropouts, this product will most likely solve the problem for you. It is the perfect solution if you have a back-to-base alarm system.
Meets Telstra's new RCIT 0004 standard as well as the Australian standard S002 Appendix F. Telstra's new RCIT 0004 is an expanded version of ETSI standards 101952-1-1 and 101952-1-5. ACIF standard S002 is the minimum requirement for ADSL Splitters/Filters with the Australian market place.
NOTE: You MUST use a licensed cabler to install this device Speak to the ACMA for further details.
After purchasing this product from us you are welcome to e-mail or call 1300 733 113 to request an "Installation and Cabling Guide" to assist your licensed cabler in correct installation procedure.
For full managed tech support & warranty click this link to C10 Communications Pty Ltd Tech Support.
Designed for
ADSL (such as on a Telstra / Telstra Wholesale port) or any speed up to 8000kbps
ADSL2 or any speed up to 12000kpbs
ADSL2+ or any speed up to 24000kbps